GCSE Physics45–60 minutes
Hooke's Law
Operate a virtual spring experiment, collect load-by-load measurements, plot a force–extension graph and calculate the spring constant.
Prior knowledge: Reading a ruler and recognising the need for eye-level readings; Weight, mass and the use of g = 9.8 N/kg or 10 N/kg; Plotting points and drawing a line of best fit; Calculating a gradient from a graph.
Timing: Allow 10 minutes for setup, 25 minutes for measurement, and 15 minutes for graphing and conclusion. The dashboard can compress the measurement phase when lesson time is short.
Open the practical
GCSE Physics45–60 minutes
Resistance of a Wire
Investigate how the resistance of a wire changes with length using a pre-constructed circuit, real meter readings and a full results-to-graph workflow.
Prior knowledge: Current, potential difference and resistance; Using an ammeter and voltmeter correctly; Rearranging V = I R; Plotting and interpreting straight-line graphs.
Timing: Allow 10 minutes to introduce the circuit, 25 minutes for readings, and 15 minutes for graphing and evaluation. The pre-built circuit removes wiring time.
Open the practical
GCSE Physics40–55 minutes
Series and Parallel Circuits
Build evidence from single, series and parallel circuits by comparing current, potential difference and total resistance.
Prior knowledge: Series and parallel circuit diagrams; Current and potential difference rules; Using ammeters and voltmeters; Rearranging R = V / I.
Timing: Allow 10 minutes for the arrangement rules, 25 minutes for measurements, and 15 minutes for comparison and conclusion.
Open the practical
GCSE Physics45–60 minutes
Current–Potential Difference
Measure and plot current–potential difference characteristics for a fixed resistor, filament lamp and diode using a correctly connected circuit.
Prior knowledge: Current, potential difference and resistance; Using ammeters and voltmeters; Plotting graphs and interpreting curves; The difference between ohmic and non-ohmic components.
Timing: Allow 10 minutes to introduce the circuit, 30 minutes for readings across the components, and 15 minutes for graphing and comparison.
Open the practical
GCSE Physics50–65 minutes
Specific Heat Capacity
Heat a metal block or insulated water calorimeter, record electrical energy and temperature change, and determine specific heat capacity from a graph.
Prior knowledge: Electrical power and energy; Heat transfer and temperature; Rearranging equations; Plotting and interpreting graphs.
Timing: Allow 10 minutes for setup, 30 minutes for heating and readings, and 15 minutes for graphing and calculation. Guided mode compresses the waiting time.
Open the practical
GCSE Physics40–55 minutes
Density
Measure mass and volume using regular solids, water displacement and mass difference, then calculate density from your results.
Prior knowledge: Measuring mass and volume; Using a ruler, balance and measuring cylinder; Rearranging equations; Plotting and interpreting straight-line graphs.
Timing: Allow 10 minutes to introduce the methods, 25 minutes for measurements, and 15 minutes for calculation and evaluation.
Open the practical
GCSE Physics45–60 minutes
Acceleration (F = ma)
Investigate resultant force, mass and acceleration using a level track, trolley, light gates and mass hanger.
Prior knowledge: Speed, velocity and acceleration definitions; Resultant forces and Newton's first law; Light gates and digital timing principles; Plotting straight-line graphs and interpreting gradients.
Timing: Allow 15 minutes for apparatus familiarisation, 25 minutes for Investigations A and B, and 15 minutes for graph analysis.
Open the practical